Warning Note - Volkswagen 7L0 092 155 A Montageanleitung

Route the red wire with eyelet and M5 nut along on the vehicle wiring harness up to the main fuse
carrier (main fuse box) under the left seat next to the vehicle battery.
Fix the wire on the connecting box to the fused side of fuse No. 3 (Ter.30).
Depending on the equipment, this connection may already be occupied and thus may be occupied
several times. In this case, remove the M5 nut from the eyelet of the red wire and connect this
together with the wire already fitted.
In event that the wiring and the signal wire assignment on the vehicle do not unequivocally coincide,
comparison with the current flow diagram may be necessary. Generally however, the following
"Signal assignment comes before signal colour"; We reserve the right to correct typing errors or
Route all of the installation kit's wiring harnesses along the vehicle's wiring harnesses,
secure them with the supplied cable ties and/or insert them into the existing cable holders.
Refit all trim parts and any parts removed.
Reconnect the earth wire to the battery.
3. Coding
The additional warning lamp (C2) for checking the operation of the trailer indicators is not
fitted to the vehicle. In addition, the trailer lights (with the exception of the fog light and
reversing light) are monitored using the light failure monitoring element in the multi-function
After fitting the electric installation kit, an online coding or a documentation update must be
• Start the ODIS diagnostics tester
• Start the "Diagnostics" function
• Select "Special functions"
• Select the sub-section "Adapt SW"
• Confirm with "Perform test"
• Select "Perform upgrading and retrofitting solutions" via button 3
• Enter and confirm SVM code 35FDF for fixed towing hitch or
SVM code 35FE3 for removable towing hitch in the input window
• Follow the instructions of the diagnosis tester
1. It must be ensured that the latest version of ODIS service is used on the workshop
tester for the vehicle test.
2. The request for the vehicle configuration (SVM code) only occurs once if the procedure
and test operation are carried out without any errors!
3. Unprompted multiple requests generate error messages and have no effect on
the configuration.
23.06.2015a051685
applies:
make alterations.
NOTE:
display.
performed using ODIS as follows:

WARNING NOTE:

13 / 91