Volkswagen 7L0 092 155 A Montageanleitung Seite 43

Installation overview
Figure 1
1 Trailer socket
2 Opening for the cable
3 Earthing point
4 Trailer connection unit
2. Fit the 12- and 9-wire wiring harnesses as well as the socket housing.
Detach the luggage compartment cover and the luggage compartment floor coverings and remove
the rear body panel trim.
Remove the trim on the C- and D-pillars and the right luggage compartment side trim.
Remove all of the access trims on the right.
Remove the fuse holder cover and fuse holder on the right front face of the dash panel.
Remove the cover on the rear of the fuse holder and open the purple secondary interlock to the side.
Remove the foot well trim under the dash panel on the right and left side.
Remove the covers from the left front face of the dash panel.
Remove the bonnet release lever and left bottom A-pillar trim and release the front left sill rail.
Undo the fixing screws of the left seat, fold the seat a little to the rear and secure against tipping.
Remove the cover of the main fuse carrier next to the vehicle battery.
Observe the safety precautions for removing and fitting the airbag components in all cases!
23.06.2015a051685
5 Fuse box
6 BCM2 control unit
7 Battery, main fuse box
ATTENTION!
9 / 91