Volkswagen 7L0 092 155 A Montageanleitung Seite 44

Remove the cover of the vehicle's 40 mm opening for the wiring harness for the towing hitch in the
luggage compartment floor panel at the back on the right.
Feed the 12-wire wiring harness out through the opening provided and fit the pre-assembled socket
insert with the supplied socket housing to the trailer hitch mounting plate as follows:
Towing hitch with closed socket mounting plate:
Cleanly prepare the pre-perforated, arch-shaped area on the right-hand (as seen from the front),
flattened side of the attached socket housing, so that the outlet is on the right.
Carefully remove the socket seal for the centre outlet, which is not needed here, without damaging
the insulating sleeving!
Insert the pre-assembled socket insert of the wiring harness into the socket housing, click it into the
supports and then use the pre-fitted screws in the socket housing to mount it on the towing hitch
mounting plate.
The supplied M5 x 24 screws and M5 nuts may not be needed
(See Fig. 2).
Towing hitch with open socket mounting plate:
Unscrew the pre-fitted M5 x 14 screws from the socket housing (they are not needed in this case).
Carefully remove the socket seal for the side outlet, which is not needed here, without damaging the
insulating sleeving!
Insert the pre-assembled wiring harness socket insert into the socket housing supplied, click into
place in the supports and mount it on the towing hitch mounting plate using the supplied M5 x 24
screws and the M5 nuts(see Fig. 3).
Figure 2
Figure 3
23.06.2015a051685 10 / 91