GeoMax Zeta125 Bedienungsanleitung Seite 65

Resetting the
Zeta125s
Auto Target
If the Alignment of the Zeta125s was not in +/-3° or +/-6° area, precede as
follows:
Step Description
1. If the narrow mode is activated:
Switch to the wide mode.
2. If the wide mode is activated:
Set up the laser again. Make sure, that the laser hits the middle of the
auto target with an accuracy of +/-6°.
Use one of the following methods to reset the Zeta125s:
a) Power down the auto target. Press the ON/OFF key for 2 seconds, until
the main beam of the Zeta125s is lit permanently.
b) Power down the Zeta125s and switch it on again.
Switching the auto alignment mode
Refer to Switching between narrow mode and wide mode.
Zeta125/ Zeta125s | 64
EN