GeoMax Zeta125 Bedienungsanleitung Seite 61

Switching
between narrow
mode and wide
mode
Detector mode
Auto Target
Step Description
1.
Press the ON/OFF key
2.
With the auto target powered down, press and hold the
ment key and at the same time turn on the auto target.
3.
Release both, the ON/Off key
same time.
4. Once the auto target is on:
If the two outside red LEDs are lit solid, the auto target is in wide mode.
If the two outside red LEDs are not lit, the auto target is in narrow
mode.
The auto target starts with the mode that was activated last.
With the detector mode you can use the auto target like a typical detector.
To enter the detector mode:
With the auto target powered down, press and hold the ON/OFF key
the left arrow key
to power down the auto target.
and the
or right arrow key
Zeta125/ Zeta125s | 60
auto alignment key at the
.
auto align-
EN
and