GeoMax Zeta125 Bedienungsanleitung Seite 63

Step 3
Step 4
Auto Target
To start the auto alignment procedure, press the auto alignment key
The green auto alignment LED is flashing and the main beam of the Zeta125s
switches off. Facing the Zeta125s from the auto target, the Zeta125s pivots to
the right. The vertical rotating beam switches on and the auto alignment
procedure begins. The vertical rotating beam pivots to the left.
The green auto alignment LED continues to stay lit. The Zeta125s pivots back
to the auto target until it hits the reception field of the auto target. Once the
vertical rotation beam of the Zeta125s hits the reception field of the auto
target, the left red LED starts flashing.
Auto alignment procedure successful
When the middle of the reception field is hit, the vertical laser beam switches
off and the pivoting stops. The main beam of the Zeta125s switches on.
A successful auto alignment procedure is indicated as follows:
• The green ON/OFF LED on the auto target lights up
• The display of the Zeta125s shows this symbol:

To protect the auto target, you can now switch off the auto target and
replace it with a standard target.
Fine positioning
If you are not satisfied with the accuracy of the auto alignment, you can fine
adjust the alignment of the Zeta125s beam. To adjust the laser beam you can
either use the left/right arrow keys on the auto target or on the Zeta125s.
Zeta125/ Zeta125s | 62
.
EN