Radio Operation; Programming Stations - Silvercrest SPU 900 A1 Bedienungsanleitung

glows in the display g. To permanently stop
an interrupted alarm, briefly press the PAGE/
AL.SET button f.
The Reminder function
The appliance will remind you of the dates
that you have programmed in with the re-
minder function. In these cases and on these
days, from 08:00 - 23:00 and on every
full hour, the reminder alarm will sound for
10 minutes. Additionally, the SDA indicator
blinks in the display g. Press any button to
end the reminder alarm.
Adjusting changing display indicators
When the appliance is in Standby, press the
button DOWN i. In the display appears
D–
" " (for Time and Date). Press the button
DOWN i once again, "
display (for Time and World Time). Press the
button DOWN i once again, "
in the display (for Time, Date and World
Time in rotation). Press the button DOWN
––
i once again, "
(only Time).
Radio operation
The technical data of the appliance makes
possible an adjustable frequency range wider
than the permitted frequency ranges of 87,5 -
108 MHz resp. 526,5 - 1606,5 kHz. In some
countries, different national regulations may
apply to the assigned radio frequency ranges.
Please note that information received outside
of the assigned radio frequency ranges may
not be used, passed on to third parties or
otherwise misused. For VHF radio reception,
completely unwind the wire aeriel 2) and, with
the radio switched on, determine the most fa-
vourable positioning for it. The appliance has
a built-in aerial for MW reception. To improve
MW reception, if required, turn the radio until
it is in the most favourable position.
Switching the radio on and off
1. Press the button
the current frequency and the switch-on
–W
" appears in the
DW
" appears
" appears in the display
l. In the display g
symbol is indicated. Next to it, the
clock symbol blinks and thus indicates
that the device is waiting for the reception
of the current time from an RDS station.
2. Press the button
switch the radio function off and return the
appliance to the standby mode.
Manual station selection
1. Use the waveband select button u to
select the required reception waveband,
MW (AM) or VHF (FM).
2. Press the button UP o to search for radio
stations with a frequency higher than the
one indicated in the display.
3. Press the button DOWN i to search for
radio stations with a frequency lower than
the one indicated in the display.
4. If the found radio station transmits RDS-
Data, the
play g glows. The display g indicates
the name of the radio station and the time
is updated (insofar as this adjustment is
activated, see the section "Programme the
Update function").
Automatic station search
You can also let the appliance search for
radio stations. The radio alarm then searches
the selected frequency range until it has
found a radio station.
1. Press and hold the button UP o for two
seconds: The radio alarm searches for the
station with the next highest frequency.
2. Press and hold the button DOWN i for
two seconds: The radio alarm searches
for the station with the next lowest fre-
quency.
Repeat these steps until you have found a
radio station to your liking.

Programming stations

For each of 2 users you can save 20 VHF sta-
tions and 12 MW stations as favourites in the
appliance. These memory slots are spread
over several pages, which can be called up
via the PAGE/AL.SET button f. On each
- 35 -
l once again to
indicator in the dis-