NovoPress ACO403 Betriebsanleitung Seite 28

ACO403
2. Swivel the outer shells of the press collar outwards as far as possible and then position the press
collar on the press fitting.
EN
3. Close the press collar. (Fig. 6)
4. Open the adaptor jaw fully using the grip.
5. Position the adaptor jaw on the press collar as follows.
Push claws (21) of the adaptor jaw as far as possible into grooves (24) in the press collar.
(Fig. 10)
6. Close the adaptor jaw using the grip.
Pos : 53 /RVT/Inbetri ebnahme und Betrieb/Ver press en/08 - Info Pr esss chling e ACO/EC O202, ACO202XL, EC O301, AF P/EFP202 @ 0\mod_1386668854154_18.doc x @ 1706 @ @ 1
Pos : 54 /RVT/Inbetri ebnahme und Betrieb/Ver press en/13c - Info Start-Tas ter 2mal dr üc ken- Bl uetooth @ 4\mod_1506329760197_18.doc x @ 32075 @ @ 1
Pos : 55 /RVT/Inbetri ebnahme und Betrieb/Ver press en/11 - Punkt 7 - 9 - ACO401 @ 3\mod_1490792442009_18.doc x @ 28973 @ @ 1
7. In order to start the process, press the start button and hold it down.
8. After the pressing operation has been completed, open the adaptor jaw using the grip and detach
it from the press collar.
9. Open the press collar and remove it.
Pos : 56 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
WARNING!
Risk of injury from ejected fragments
If the adaptor jaw is positioned on the press collar incorrectly, the adaptor jaw and the
press collar may break.
Therefore
– Claws (21) of the adaptor jaw must grip pins (22) of the press collar.
(Fig. 11, 12 + 13)
Information!
Ensure there is no gap between the segments of the press collar when the
pressing operation is complete.
Information!
If the press device is switched off, briefly press the start button (1) to activate the
press device. Press the start button again to start the pressing operation.
24