Werbung
RAID Subsystem DVA-12T
3
Installation Procedures
To install the subsystem use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
4
Unpacking the Subsystem
Check the included Unpacking Checklist and verify the model name and shipping contents
against the checklist.
5
Rack Mounting
Slide rails are required for rack mounting. For rack mounting use only one of the following
slide rail kits:
Slide rails for 533 mm to 724 mm deep racks
(21" to 28.5")
Slide rails for 647 mm to 914 mm deep racks
(25.5" to 36")
Table 5.1 Slide rail kits
NOTICE!
Refer to Slide Rail Kit Installation Manual for detailed information.
Bosch Sicherheitssysteme GmbH
Unpack the Subsystem (see Section 4 Unpacking the Subsystem)
Install the system in the rack (see Section 5 Rack Mounting)
Install the Drive Tray (see Section 6 Drive Tray Installation)
Connect the Subsystem Cable (see Section 7 Subsystem Cable Connections)
Power On (see Section 8 Power On)
Configure the Host Computer (see Section 9 Configuring the Host Computer via a Network)
Change the IP Address (see Section 10 Changing the Configuration via a Web Browser)
Change the factory default settings (see Section 10.2 Guidelines for Setting up a RAID)
Connect a Bosch Video Server (see Section 12 Connecting a Bosch Video Server)
Quick Installation Guide
Installation Procedures | en
DVA-12T
DVA-ASRK-28A
DVA-ASRK-36A
F.01U.027.801 | V5 | 2010.06
55
Werbung
Kapitel
