Internal Cleaning; Troubleshooting - Electrolux GA55SLICN Benutzerinformation

11.5 Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a
soft damp cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration

12. TROUBLESHOOTING

The vast majority of problems that
can occur during daily operation can
be easily solved without the need to
contact an Authorised Service Cen-
tre and will save time and money.
In this chapter we will help you to
recognize and solve these problems.
WARNING!
Repairs not properly done
may result in serious risk to
the safety of the user. Any
repairs must be performed by
qualified personnel.
12.1 Poor washing results
• The baskets have been overloaded.
• Tableware has not been properly
arranged.
• The quantity of detergent was not
enough.
• The detergent was not suitable or old.
• The programme was not appropriate
for the degree of soil and the type of
load.
• The spray arms were blocked by the
tableware and could not rotate freely.
• The spray arms are clogged.
• The filters are clogged or not
positioned correctly.
• The selected level of the water softener
is not appropriate for the hardness of
your water supply.
12.2 Poor drying results
• Tableware has been left too much time
inside a closed appliance.
• The selected programme has no drying
phase.
programmes at least 2 times per
month.
• To maintain the performance of your
appliance at its best, we recommend
to use monthly a specific cleaning
product for dishwashers. Follow
carefully the instructions on the
packaging of the product.
• The selected programme has a drying
phase with low temperature.
• The dosage of rinse aid is not enough.
Set the rinse aid dispenser to a higher
level.
• There is no rinse aid in the rinse aid
dispenser.
• Plastic items may need to be towel
dried.
• Dishes have not been arranged
properly in the baskets.
• Arrange the tableware avoiding, if
possible, contact points. This will allow
water to reach all surfaces.
• Arrange kitchen utensils in a sloping
position.
• The interior of the appliance is wet
caused by the humidity in the air that
condenses on the inner sides of the
appliance. This is not a defect of the
appliance.
• Multi-tablets may give poor drying
results. Try a different brand of multi-
tablets. The use of rinse aid together
with multi-tablets can help to increase
drying performance.
• The cutlery is not dry. Cutlery has not
been arranged properly in the cutlery
basket.
12.3 Traces of rust on cutlery
• A lower grade of stainless steel of the
cutlery is less resistant to corrosion in
damp dishwasher environment. Use
high grade stainless steel or remove
the items from the appliance
immediately after the end of the
programme.
• There is too much salt in the water
used for washing. This could be
caused by the salt cap that is not
correctly closed or if the salt container
ENGLISH 19