Programming The Code Button - Becker Centronic Easycontrol Ec513 Montage- Und Betriebsanleitung

Programming the code button

In order to operate a receiver using the code button, it must first be pro-
grammed. Program the code button as an additional transmitter. A program-
ming code is necessary for this procedure. This code can be found in the en-
closed information sheet. The user can change the programming code indi-
vidually to a different number combination.
Put the receiver into programming mode using the mas-
ter transmitter.
Always observe the assembly and operating in-
structions of the master transmitter.
Press the "P" button for at least 3 seconds.
▻ The LED flashes slowly.
Enter the programming code (e.g. 1234). The code spe-
cifically preset for the code button is included in delivery
with the product.
▻ The LED flashes slowly.
Now press the "Key" button.
▻ The LED lights up.
Now select the required channel via the 1, 2 or 3 buttons.
▻ The blue LED lights up.
Now press and hold the "Key" button.
▻ The receiver confirms once.
Now press and hold the "Key" button again.
▻ The receiver confirms twice.
► The receiver has now been programmed.
23 - en