Boiling Water - Silvercrest SWKT 3000 B2 Bedienungsanleitung

Boiling water

RISK - ELECTRICAL SHOCK!
Never place the electrical base 3 close to water – this would be a
►
potentially fatal risk!
WARNING - RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has
already stood in the kettle for longer than one hour. Do not reboil water
that has cooled down. Always pour old water away. Microbes could have
formed in it!
NOTE
Always ensure that the ON/OFF switch 2 is turned to "O" when the
►
mains plug is unplugged and the device is standing on the base 3.
If not, the device could heat up unintendedly as soon as the mains plug is
plugged in again.
1) Lift the kettle off of the base when fi lling it!
2) Press the unlocking button 1 and open the lid.
NOTE
► When fi lling it, hold the kettle upright. This is the only way to read the
markings on the scale 6 correctly.
3) Fill the kettle...
–
–
4) First close the lid, then place the kettle on the base 3, so that it sits securely
on the base 3.
5) Adjust the temperature regulator 5 to the required setting. To bring the
water to the boil, you have to set the temperature regulator 5 to the MAX
position in the boiling range (area marked red on temperature regulator 5).
6) Now insert the plug into the mains power socket.
7) Press the ON/OFF switch 2 downwards so that it engages.
8) The integrated indicator light in the ON/OFF switch 2 indicates that the
appliance is now heating up.
SWKT 3000 B2
to at least the MIN mark, so that the appliance does not overheat,
to maximum the MAX mark, so that boiling water cannot spill out.
GB
CY
7