CAMPAGNOLO PISTA Bedienunganleitung Seite 46

10.2 - DISASSEMBLY AND ASSEMBLY OF THE REAR HUB
• Position Campagnolo ® tool UT-HU020 in a vice.
• Fit the threaded end of the hub axle (track sprocket side) in the biggest
hole in the tool and tighten the vice (not excessively) (Fig. 33).
• Unscrew the LH counter-cone (A - Fig. 34) using a Campagnolo
wrench (UT-BR010 - Fig. 33) countering the rotation of the axle with ano-
ther 13 mm cone wrench (Fig. 33) fully inserted on the LH cone (C - Fig.
34), then remove the washer (B - Fig. 34).
• Unscrew and remove the LH cone (C - Fig. 34) with the 13 mm cone
wrench.
• Remove the wheel from the vice.
• Slide the axle (D - Fig. 34) out of the hub body.
• Remove the dust
34
cap (E - Fig. 34).
®
A B C E
33
13 mm cone
CLOSE
E
UT-BR010
OPEN
OPEN
UT-HU020
D
CLOSE
21