CAMPAGNOLO PISTA Bedienunganleitung Seite 40

• Remove the nut and plate, then slide the spoke out of the rim (Fig. 21).
• Slide the spoke out of the hub (Fig. 22).
• Insert the new spoke in the hole in the hub (Fig. 23), then insert it in the hole in the rim (Fig. 24).
• Fit the plate on the spoke, keeping the concave part facing outwards and position it in the special groove
on the rim; when fitting a spoke on the LH side of the wheel, the long side of the plate must face leftwards
and vice versa, as illustrated in figure 18 - Page 13.
• Tighten the nut.
Attention
After completing the operation, check that the flat spoke (aero) is oriented in an aerodynamic position (Fig. 19
- Page 13).
WARNING!
When fitting the wheel, check that the plates remain in position since an incorrectly positioned
plate may caused irreparable damage to the profile of the rim when tensioning the spokes. This
damage could cause the rim to
unexpectedly fail, resulting in
an accident, personal injury or
death.
Following the operations described
in Section 9:
• Tighten and Settle the Spokes.
• Check centering and wheel
dishing.
22 23
21
24
15