Herunterladen Inhalt Inhalt Diese Seite drucken

Motion CL Serie Kurzanleitung Seite 8

Mobile dockingstation mit und ohne stromversorgung
Vorschau ausblenden Andere Handbücher für CL Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
English
This document contains regulatory, precautionary, and recycling informa-
tion for the Motion CL-Series Mobile Dock Model TLD002. To avoid injury,
read this document and understand its contents before you use the Mobile
Dock. Keep this document nearby, so you can refer to it later.
For detailed operating instructions and safety information, see
www.motioncomputing.com/docs
The Motion Mobile Dock Model TLD002 is marketed and/or known as the
CL Series Mobile Dock with Key Lock.
Product safety information
Motion Mobile Docks are designed to optimize safety and minimize strain.
However, to further reduce the risk of injury or damage to the unit, you
should observe certain precautions.
Mounting and installation disclaimer
Motion Computing shall not be liable under any theory of liability (includ-
ing, without limitation, contract, tort or statutory law) for any loss, damage,
personal injury, or other damage of any nature (including, without limita-
tion, direct, special, incidental or consequential damages) arising directly or
indirectly as a result of improper or inappropriate placement, installation, or
use of its products or any other application. To safely install and use Motion
products, full consideration of occupants, systems (e.g., the location of fuel
lines, navigation systems, brakes lines, electrical, drive train or other sys-
tems), air-bags and other back-up, warning or safety equipment is required.
Without limiting the foregoing, Motion specifically disclaims any respon-
sibility for the placement, use, or installation of its products not consistent
with (i) the original manufacturer's or governmental or regulatory specifica-
tions and recommendations for the environment where the products will
be placed, used, or installed, (ii) Motion written product instruction sheets,
or (iii) workmanship standards.
Basic personal safety precautions
• 
Do not attempt to service the Mobile Dock or its components yourself.
Perform only those service procedures for which Motion provides
special instructions, for example, installing a peripheral device.
• 
Do not connect or disconnect any cables or perform maintenance or
reconfiguration of this product during an electrical storm.
 
Mobile Dock disposal
• 
Do not dispose of the Mobile Dock with general waste.
• 
If you cannot locate a disposal site, contact your reseller or Motion
Computing for assistance in locating a disposal site near your locale.
Regulatory and safety compliance
The following sections describe regulatory and safety compliance by coun-
try and by region.
Note: To determine which regulatory and safety marks apply to a specific
product, component, or accessory, check the product label affixed to the
product and/or its components.
Federal Communications Commission notice (USA)
Electromagnetic Interference (EMI) is any electromagnetic disturbance
that interrupts, obstructs, or otherwise degrades or limits the effective
performance of electronics or electrical equipment. These emissions can
potentially disrupt, degrade, or otherwise interfere with authorized elec-
tronic emissions, which may include television, AM/FM broadcasts, cellular
services, radar, air-traffic control, and pagers.
The FCC Rules and Regulations have established Radio Frequency (RF) emis-
sion limits to provide an interference-free RF spectrum. Many electronic de-
vices, including computers, generate RF energy incidental to their intended
function and are, therefore, covered by these rules.
8
Unintentional Emitter per FCC Part 15
The rating label on the CL-Series Mobile Dock and all accessories show which
class (A or B) these devices fall into. Once you determine the class of the device,
refer to the following corresponding statement and to the FCC notices in this
Safety and Regulatory guide.
• 
Class A is a digital device that is marketed for use in a commercial, industrial
or business environment, exclusive of a device which is marketed for use by
the general public or is intended to be used in the home.
• 
Class B is a digital device that is marketed for use in a residential environment
notwithstanding use in commercial, business and industrial environments.
Examples of such devices included, but are not limited to, personal
computers, calculators, and similar electronics devices that are marketed for
use by the general public. This device complies with Part 15 of the Federal
Communications Commission (FCC) Rules. Operation is subject to the
following two conditions:
-
This device may not cause harmful interference.
-
This device must accept any interference received, including interference
that may cause undesired operation.
Class A Equipment: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the manufacturer's instruction manual,
may cause interference with radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case you will
be required to correct the interference at your own expense.
Class B Equipment: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the manufacturer's instruction manual, may
cause interference with radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, you are encouraged to try to correct
the interference by one or more of the following measures:
• 
Reorient or relocate the receiving antenna.
• 
Increase the separation between the equipment and the receiver.
• 
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• 
Consult the dealer or an experienced radio/television technician for help.
 
The following information is provided on the device or devices covered in this
document in compliance with FCC regulations:
Motion CL-Series Mobile Dock Model Number: TLD002
Company name: Motion Computing, Incorporated
8601 Ranch Road 2222, Bldg 2
Austin, TX 78730 USA
Telephone: 512-637-1100
Fax: 512-637-1199
Manufacturer name: Sinbon Electronics Co. Ltd.
4F-13, No. 79, Hsin Tai Wu Rd. Sec 1, Hsi-Chih, Taipei Hsien 221, Taiwan. Taiwan
Telephone: (886 -2) 26989999
Fax: (886-2) 2698-9660
Modifications
The FCC requires that you be notified that any changes or modifications made to
this device that are not expressly approved by Motion Computing, Inc. may void
your authority to operate the equipment.
Cables
Connections to this Mobile Dock must be made only with shielded cables. This
reduces possible interference with radio communications and complies with FCC
Rules and Regulations for this EMC classification.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Tld002

Inhaltsverzeichnis