What To Do If - Becker Centronic SunWindControl SWC441-II Montage- Und Betriebsanleitung

Assembly and Operating Instructions
Problem
Drive is not function-
ing.
Automatic control
commands are not
executed.
The system is not
extended automatically
when the sliding switch
is set to "S".
The system does not
extended manually
when the sliding switch
is set to "H" or "S".
22
What to do if ...?
Cause
1. Battery is flat.
2. Battery is inserted
incorrectly.
3. Receiver outside the
radio range.
4. Transmitter is not
programmed in the
receiver.
1. Sliding switch not in the
"H" position.
2. The automatic sun
protection function
was interrupted by a
manual command.
1. Sunlight intensity is
below the threshold
value.
2. Wind speed exceeds
threshold value.
Wind speed exceeds
threshold value.
Remedy
1. Insert new battery.
2. Insert battery cor-
rectly.
3. Reduce distance to
the receiver.
4. Programme transmit-
ter.
1. Set sliding switch to the
"S" position.
2. Turn the sliding switch
from "S" to "H" and
back to "S".
1. Adjust sun threshold
value.
2. Wait until wind abates.
Wait until wind abates.