Audio-Player - Monacor PAS-250D Bedienungsanleitung

5.1 Audio player
The integrated audio player can reproduce audio
files in the MP3 or WAV format . USB flash drives
or SD[HC] memory cards (also MMC cards) can
be used as storage media .
Note: Due to the large number of storage device manu-
facturers and device drivers, it cannot be guaranteed that
all storage media are compatible with the audio player .
Insert a USB flash drive into the USB port (1)
and /or insert a memory card (contacts facing
upwards) into the slot (2) .
When the unit is switched on, the audio file
most recently replayed will be selected and the
audio player will be in the pause mode (indi-
cation: ) . The USB flash drive will take
priority over the memory card . When a storage
medium is inserted during operation, it will be
automatically selected .
The audio player can be operated via the but-
tons (4) or the remote control provided (fig . 3)
☞
( chapter 5 .3) . Point the remote control to the
infrared sensor on the right of the display (3) .
The display indicates the time played of the
current title . The volume of the replay depends
on the settings of the audio player and the con-
trol PLAYER (11) .
5.2 Bluetooth receiver
As an alternative to the reproduction from a
USB flash drive or a memory card, the integrat-
ed Bluetooth receiver can be used for wireless
connection to a Bluetooth audio source (e . g .
smartphone or tablet computer) .
1) When no USB flash drive and no memory
card is connected, the PAS-250D will be auto-
matically in the Bluetooth mode: The display
(3) will show
When a storage medium is connected, press
the button M repeatedly until neither
lights up on the left of the display . The
USB
display will show
14
.
after a few seconds .
2) Activate the Bluetooth function at the
Bluetooth source . PAS-250D (designated
as "BT-SPEAKER") will appear in the list of
available units .
3) Pair the source with "BT-SPEAKER" (if re-
quired, see the instruction manual of the
Bluetooth source) . The two units will then
be automatically connected .
Once the connection has been established,
a two-tone sequence will sound .
The replay via the Bluetooth receiver can be con-
trolled by means of the buttons (4) or the remote
control provided (fig . 3) (
the remote control to the infrared sensor on the
right of the display (3) .
The volume of the Bluetooth replay de-
pends on the settings of the Bluetooth source,
the audio player / Bluetooth receiver and the
control PLAYER (11) .
When neither the audio player nor the
Bluetooth receiver are used, switch them off by
means of the remote control (button
will increase the operating time of the battery
and prevent any undesired Bluetooth reception .
Mode
−
EQ
0
1 2
4 5
7 8
nor
TF
➌
Remote control
☞
chapter 5 .3) . Point
+
U/SD
SCAN
3
6
9
) . This