Operating Elements And Connections; Safety Notes - Monacor PAS-250D Bedienungsanleitung

Portable Amplifier System
These instructions are intended for users without
any special technical knowledge . Please read
these instructions carefully prior to operation
and keep them for later reference . All operat-
ing elements and connections described can be
found on page 2 .
1 Operating Elements
and Connections
1 USB port (type A) for the connection of a USB
flash drive to reproduce audio files
2 Slot for an SD memory card to reproduce
audio files
3 Display to indicate the Bluetooth function or
the storage medium selected and the current
title number or the time played of the title
4 Control buttons for the audio player / Blue-
tooth receiver (
5 Combined XLR / 6 .3 mm jack 1 MIC / LINE IN
for the connection of a microphone or of
another mono audio source (e . g . mixer)
6 Volume control LEVEL for a microphone or
audio unit connected to (5)
7 Volume control 2 WIRELESS for a wireless
microphone
8 Common sound control TONE for a micro-
phone or audio unit connected to (5) and for
a wireless microphone
9 RCA jacks 3 LINE IN for the connection of an
audio source (e . g . CD player); when a stereo
audio source is connected, a mono signal will
be created in the amplifier
10 RCA outputs LINE LINK to record the mixed
signal or to route it to another amplifier
system; for stereo recorders, two jacks are
available
11 Volume control PLAYER for the input 3 LINE
IN (9) and for the audio player / Bluetooth
receiver
12 Sound control TONE for the input 3 LINE
IN (9) and for the audio player / Bluetooth
receiver
10
☞
chapter 5 .3)
13 Function VOICE OVER to mute the sound
of an audio source connected to the input
3 LINE IN and of the audio player / Bluetooth
receiver while speaking into the microphone
LED MUSIC will light up when the sound
is muted
Control DEPTH to adjust the sensitivity for
muting the sound
14 LED status indicators for the rechargeable
battery
CHARGE Red: during the charge process
Green: when the charge pro-
FULL charging state: full
OK charging state: sufficient
LOW charging state: low
15 LED indicator LIMITER; will light up when the
level limiter is active
16 Power indicator PWR ON
17 Power switch
18 Connection jack to charge the battery; only
use the charger provided
19 Switch INTERNAL SPEAKER to switch on / off
the two speakers of the amplifier
20 Jack EXT .SPEAKER for the connection of an
(additional) speaker
21 Cover for the battery compartments

2 Safety Notes

The units (amplifier system and charger) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The charger uses dangerous
mains voltage . Leave servicing
to skilled personnel . Inexpert
handling may result in electric
shock .
•
Never use the amplifier system in heavy rain
and always make sure that no moisture will
get into the system .
The charger is suitable for indoor use only .
Protect it against dripping water, splash water
cess has been termi-
nated
.