Commissioning And Operation - NovoPress ACO203 BT Betriebsanleitung

Pos : 46 /RVT/Inbetri ebnahme und Betrieb/Ger ät vorberei ten/1f - Quetsc hgefahr Finger AC O203/ACO203 BT/ECO203 @ 5\mod_1518435538646_18.doc x @ 34628 @ 12 @ 1
8

Commissioning and operation

8.1 Preparing the ACO203 / ACO203 BT / ECO203
CAUTION!
Fingers risk being crushed if the device is operated without a press
jaw/adaptor jaw (Fig. 4)
If no press jaw/adaptor jaw is fitted, fingers could be placed in the at-risk zone. Fingers
could be crushed when the device is started.
Therefore:
–
–
Pos : 47 /RVT/Inbetri ebnahme und Betrieb/Ger ät vorberei ten/3 - Info-H altebolzen ACO/EC O202, ECO301, AC O/ECO203 @ 0\mod_1382617008258_18.doc x @ 1559 @ @ 1
Information!
The device will not start if the retaining pin (8) is incorrectly inserted. The green LED
flashes.
Pos : 48 /RVT/Inbetri ebnahme und Betrieb/Ger ät vorberei ten/4 - Info D auer betrieb ACO102, AC O152, ACO/EC O202, ACO202XL, EC O301, AF P/EFP202 @ 0\mod_1382617729764_18.doc x @ 1565 @ @ 1
Information!
The press device is not suitable for continuous operation. Following 30 minutes
of continuous operation, a short break of at least 15 minutes must be taken to
allow the device to cool down.
Pos : 49 /RVT/Inbetri ebnahme und Betrieb/Ger ät vorberei ten/5b - Ei ns etz en AC O/ECO202, AC O/ECO203 @ 0\mod_1385646619856_18.doc x @ 1596 @ @ 1
•
Pos : 50 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
Do not operate the device without press jaws.
Keep your fingers away from the at-risk zone.
Insert the press jaw/adaptor jaw into the press device as shown in Fig. 5 to 7.
ACO203 / ACO203 BT / ECO203
19
EN