Hardwareinstallation - Conceptronic C4PUSB2 Schnellinstallationsanleitung

ENGLISH
A. First of all, pull the USB cable out of the side of the USB Hub.
B. Connect the USB cable to the computer. The USB Hub will be automatically found and
installed in your operating system, no additional drivers are needed.
C. When the device is installed you can connect your USB devices to your USB Hub.
Depending on your USB device you might need to install a driver for the USB device.
Note: The USB Hub only supports low power devices, such as mice, keyboards, USB,
flashdrives etc.
If you connect a high power USB device (such as a external hard drive), make sure
the devices makes use of its own power supply.
Your Conceptronic 4 port Travel USB 2.0 Hub is now ready to use!
2. Hardware installation
4