Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In case that the tightening tool has reached the stop and not having reached the required torque first tighten
the vaulted jacks up. Then turn the sledge of the tool to the initial position and reposition the tool by pushing
the excenter lever upwards. Please repeat step 5.
After reaching the needed torque on the tool tighten the tightening jacks using the torque wrench of 15 Nm.
Loosen the tightening tool, push the excenter lever upwards and remove the tightening anchor band.
Finished!
17
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
