Inhaltsverzeichnis
Werbung
quindi molto grati se, dopo aver utilizzato un
ns. prodotto, vorrà compilare il QUESTIONARIO
SODDISFAZIONE CONSUMATORE, segnalando
eventuali osservazioni o suggerimenti, che troverà nel
nostro sito internet: www.pegperego.com
SERVIZIO ASSISTENZA PEG-PÉREGO
Se fortuitamente parti del modello vengono perse
o danneggiate, usare solo pezzi di ricambio originali
Peg Pérego. Per eventuali riparazioni, sostituzioni,
informazioni sui prodotti, vendita di ricambi originali
e accessori, contatta il Servizio Assistenza Peg Pérego
indicando, qualora fosse presente, il numero seriale
del prodotto.
tel. 0039/039/60.88.213
(contattabile da rete fissa)
fax 0039/039/33.09.992
e-mail assistenza@pegperego.it
pegperego.com
EN_English
Thank you for choosing a Peg Perego product.
WARNING
_ IMPORTANT: read the instructions carefully before
use and keep them for future reference. The child
may be hurt if you do not follow these instructions.
_ This vehicle was designed for transporting one child
in the seat.
_ Do not use this product for a number of passengers
greater than that stated by the manufacturer.
_ Never leave the child unattended.
_ This item was designed for use in combination with
Peg Perego Ganciomatic products. Classico 58.5 Chassis
+ "Navetta" or "Primo Nido" bassinet unit is approved
for children from birth up to a weight of 9 kg. Classico
58.5 Chassis + "Primo Viaggio" car seat (group 0+) is
approved for children from birth up to a weight of 13 kg.
_ Before use, check that the Peg Perego Ganciomatic
products are properly attached to the item.
_ The assembly and preparation procedures for the
item must be conducted by adults.
_ Do not use the item if there are missing or broken parts.
_ Always apply the brake when at a standstill.
_ Before use, check that all the attachment mechanisms
are correctly engaged.
_ Avoid inserting fingers into the mechanisms.
_ Take care if the child is present while adjusting the
mechanisms (handlebar, backrest).
_ Any loads hanging on the handlebar or handles may
make the product unstable; follow the manufacturer's
instructions regarding maximum loads.
numero verde: 800/147.414
sito internet www.
_ Do not put loads of over 5 kg in the basket. Do not
put loads into the cup holder greater than that
specified on the cup holder itself and never use it for
hot drinks. Do not put items weighing more than a
total of 0.2 kg into the hood pockets (if present).
_ Do not use the product close to stairs or steps. Do not
use close to heat sources, naked flames, or dangerous
objects within reach of the child.
_ It could be dangerous to use accessories which are
not approved by the manufacturer.
_ This item is not suitable for jogging or roller skating.
INSTRUCTIONS FOR USE
1 FITTING THE HANDLEBAR: with a screwdriver, release
the two screws and covers from the two ends of the
handlebar (fig_a). Insert the handlebar into the two
frame tubes of the closed chassis (fig_b), put the screws
and covers in place (fig_c) and fasten them, without
excessive force, on both sides of the handlebar.
2 FITTING THE WHEELS: remove the 4 packing protector
caps from the chassis wheel spindles (fig_a). Insert the
two wheels on the handlebar side (fig_b) and the other
two wheels opposite the handlebar (fig_c), taking care
to insert the wheel spokes into the slots in the spindle.
Press the wheels until they click into position (fig_a)
and check that they are firmly attached.
3 BRAKE: to apply the chassis brake, lower the brake bar
(fig_a). To release the brake, raise the brake bar.
4 OPENING: before opening the chassis, apply the
brake. To open the chassis, release the closing
catches, pushing them towards the inside (fig_a),
raise the handlebar and rotate it upwards until it
clicks into position (fig_b). Look at the safety catch
(fig_c) to see if the chassis is open properly; if the
colour red is visible (fig_d), push the handlebar down
further until it clicks into position.
5 ADJUSTABLE HANDLEBAR: to adjust the height of the
handlebar, press both side buttons at the same time (fig_
a), and lock the handlebar in the desired position (fig_b).
6 WHEEL REMOVAL: to remove the wheels, rotate the
lever in the centre of the wheel (fig_a) and at the
same time pull the wheel outwards (fig_b).
7 The tyres of the Classico Velo 58.5 chassis are inflatable.
To inflate them, unscrew the cap and use a pump.
8 FOLDING UP: To fold up the chassis, push the handle
down gently (Arrow_a), pull the two levers on the handle
upwards (Arrow_b), lift the safety clip on the side (Arrow_
c), then rotate the handle forwards and down until it clicks.
9 When the chassis is closed, check that the closing
catches are correctly engaged.
GANCIOMATIC SYSTEM
10 Ganciomatic System is the quick, practical system that
makes it possible to attach a Navetta or PrimoNido
bassinet unit or a Primo Viaggio Tri-Fix car seat to the
Ganciomatic base of the Classico 58.5 chassis in a single
step. The Navetta, the PrimoNido and the Primo Viaggio
Tri-Fix car seat are available for purchase separately.
Always apply the chassis or stroller brake before
attaching and removing products (consult the
respective instruction manuals).
Check that the child transport unit is properly attached.
SERIAL NUMBERS
11 CARRELLO CLASSICO VELO reports information as at
the date of manufacture of the product.
_ Product name, date of manufacture and serial number
of the product.
This information is essential in the event of any complaints.
CLEANING AND MAINTENANCE
PRODUCT MAINTENANCE: protect from the weather:
water, rain, or snow; prolonged and continuous exposure
to bright sunlight may give rise to colour changes of
- 8 -
Werbung
Inhaltsverzeichnis
