Programing Number Pads - Merrychef Mealstream EC401 Anleitung

PROGRAmmING NumbER PADS
Pre-programming allows repetitive cooking procedures to be stored for ease
of use in up to 0 programs ( on menukey models up to 00 programs).
Each program can comprise up to three stages, allowing at each
independent control of Convection temperature, Stage time and Microwave
power level. However, programs must be used with caution since if the
food to cook varies in weight or density then good results and more
importantly adequately cooked food may not be achieved. Therefore, it is
vital that all food prepared for service should be checked to ensure that
core temperatures have been achieved.
 Press and hold PROGRAM PAD until a flashing 'P'
appears in the PROGRAM DISPLAY
 Lights on the TEMPERATURE
SETTING PADS flash to indi-
cate that a temperature must be
selected.
Press the pad for the required
temperature, the light on the se-
lected pad will continue to flash,
the others will go out.
3 Enter required cooking time by
pressing the TIME SET PADS
(The display colons flash to indi-
cate a time is required).
Only valid times of Minutes and Sec-
onds will be accepted.
e.g.  minute  second not 61 secs
4 To cook the food using a combina-
tion of convected heat and micro-
wave press one of the POWER PADS
00%,75%,50% or 5%.
To cook using convection only press the
button marked with the fan symbol.
To save as a single stage program
Press the required number pad
example: stage 1 saved as Program 8
non-Menukey
models
Menukey
models
The program details
are displayed
momentarily as the
program is saved.
To save as a multi-stage program
Follow steps – 4 for each stage
of cooking and on completing
press the PROGRAM PAD to
enter a second and third stage of
cooking to the program.
Press the required number pad to
save the program.
example: stage 1, stage 2, stage 3
saved as Program 8, 08

MENUKEY
Note: some MENUKEY settings
will prohibit the programming of
individual number pads
An amount of experimentation
will be required to determine the
correct program for a particular
product.
Menukey models show a flashing
'PP' in the display
Check program details on the
flashing display. Settings can be
changed by stepping back through
the program using the CANCEL
BUTTON.
MENUKEY models
These store up to 00 programs
and need to be stored and
accessed by  buttons 00-99
• Enter a valid time up to 30
minutes e.g.
 minute  second not 6
seconds.
• Information may be
programmed into the memory
whether the oven is hot or
cold.
• To review a program use
CALLBACK see page 3.
We recommend you keep a
note of program instructions
for future reference.
Menukey
models