Further Setting Possibilities - Silvercrest KH 2299 Bedienungsanleitung

Further setting possibilities

Setting the display brightness
Press the button LIGHT/DIMMER j repeatedly to set the
brightness level at which the display should be illuminated.
The brightness can be set at 3 levels.
Illuminated clamp strip
Documents, for example recipes, with a width of up to 10 cm
can be inserted and automatically held in the clamp strip d.
If you press and hold the button LIGHT/DIMMER j for two
seconds, the downward facing lamp is switched on, which
then illuminates the recipe. Press and hold the button j once
again for two seconds to switch the lamp off.
Kitchen timer
1. Press the button TIMER s.
2. Using the buttons UP
time interval (a time span between 1 minute and 23:59
h is possible). Pressing and holding one of the buttons
changes the display in ten-minute intervals. Or press one
of the buttons M1–M4 t–i to recall a saved preset
time for the kitchen timer. The following times are factory
pre-programmed:
Button M1 t = 5 min. (Indicator = T1)
Button M2 y = 10 min. (Indicator = T2)
Button M3 u = 15 min. (Indicator = T3)
Button M4 i = 20 min. (Indicator = T4)
3. Press the button TIMER s once again to start the kitchen
timer. In the display r a clock icon running in reverse
and a cooking pot symbol appears.
4. From 30 seconds before expiry of the time span an acoustic
signal sounds, repeating at shorter intervals the closer the
set time approaches. When the time has expired, the alarm
sounds continuously and with increasing volume.
5. Press the button TIMER s to terminate the acoustic signal.
Interrupting the kitchen timer.
• To interrupt the kitchen timer, switch to the kitchen timer
mode by pressing the button TIMER s.
• Then briefly press the button TIMER
kitchen timer.
The time is halted, the indicator blinks for 10 seconds. After
this period the appliance returns to automatic modus. To
restart the kitchen timer, briefly press the button TIMER s
again to switch back into the kitchen timer mode.
/DOWN
 
- 10 -
1(/l, set the desired
s to interrupt the