Prelistening (Program-Monitoring); Channel Gain; Channel Equalization; Replaceable Components (Faders, Crossfader And Input Selector) - Ecler HAK300 Bedienungsanleitung

4.2. Prelistening (Program-Monitoring)

The HAK is equipped with a prelistening system that enables the monitoring of the
main inputs through the VU-meter and the headphones. Thanks to the Program-Monitor
function (21) and the Monitor crossfader (23) it's possible to quickly fade between the two
prelistening channels.

4.3. Channel gain

All the HAK300 input channels have accessible input sensitivity GAIN (20-31) or ADJ
(MIC-13) controls. These controls have the function of compensating for differences of level
existing between the sound sources connected to the table.
All input sensivity adjustments must be done very carefully using the VU-METER
and/or headphones as a reference and avoiding that all the red LEDS of the VU-METER light up,
otherwise input could be clipped (Overload). MIC input gain control is located in back panel
(ADJ 13).

4.4. Channel equalization

The tone controls for each of the two main channels provide a +10/-30dB boost/cut
at high and low frequencies. This great attenuation range is specially indicated for the already
famous "kill" effect, which nearly "cuts" the band over which it performs. Following indications
of experienced DJs, we have arrayed the control-knobs of the EQ section horizontally. This
placement enables a more comfortable area to work with. Moreover MICRO channel has two
band (bass, treble) tone control.
ATTENTION: Use equalization carefully, by boosting too much the low frequency
range, you can induce an excessive displacement of the speakers membrane.

4.5. Replaceable components (faders, crossfader and Input Selector)

In addition to an internally modular assembly system, the HAK have mounted in an
easy-to-replace module all the main components that suffer an especially high wear.
The HAK300 uses a new generation of faders based on the VCA concept
(VCA=Voltage Controlled Amplifier), offering an exceptional precision and smoothness. This
fader can achieve a lifetime of 300.000 cycles, (30 times more than a high quality mechanical
fader). After this time period, and if the faders have been constantly abused, they will show
signs of malfunction.
The crossfader now incorporates 2 metallic trimmer detents on its ends so as to
reduce the cur-in-time travel and maximize the "battle" performance of the mixer. The 2
metallic pieces can be mounted into 4 positions reducing the cut-in-time travel of 0, 2, 3 or
4mm. The trimmer detents are assembled with the crossfader screws. The mechanical detents
are originally mounted with the 0mm position. See Fig.3.
7