Maxtor MaxAttach NAS 4100
Familiarizing Yourself with Your MaxAttach NAS 4100
Front Panel
The MaxAttach front panel has four LEDs. Three are grouped together on the right side, one on
the left. The LEDs indicate the following:
• Far left LED (soft power switch). Solid LED indicates power on. This LED will blink during
boot-up, and will also blink to indicate error conditions (See MaxAttach Users Guide for fault
codes).
• Network Link 1 for LAN 1. Flashing indicates network activity.
• Network Link 2 for LAN 2. Flashing indicates network activity.
• Hard disk drive LED indicates read/write activity.
SOFT POWER SWITCH
Back Panel
Each Ethernet Port has two LEDs. One indicates link and the other activity.
On units with a Gigabit Ethernet option installed, additional LEDs will be present.
NOTE:
(BACK PANEL)
POWER
CONNECTION
Pre-Installation Planning
Figure 1-1. LEDs
UPS
CONNECTION
FAN
CONNECTIONS
FOR Field Service Personnel ONLY
Figure 1-2. NIC connections, Back Panel
HARD DISK
LAN 2
LAN 1
LAN 1
Gigabit
LAN 2
Option
3
DRIVE
SCSI
PORT