Installing Maxneighborhood Software - Maxtor MaxAttach NAS 4100 Anleitung

Maxtor MaxAttach NAS 4100
Press the soft power switch on the front panel (shown below), to turn on the unit.
3
(FRONT PANEL)
SOFT POWER SWITCH
Figure 2-3. Soft Power Switch, Front Panel
The LED in the power switch will come on. After a few moments it will begin blinking, and continue to
blink for several minutes during the power-up cycle. When the power light stops blinking and disk activity
stops, your MaxAttach is ready to configure.

Installing MaxNeighborhood Software

Use a workstation that is logged onto the network where the MaxAttach unit is connected. Insert the
MaxAttach Installation and Documentation CD into your CD-ROM drive. If the "Welcome to the
MaxAttach NAS 4100" screen does not appear, the auto-insert notification for the CD has been turned off.
In this case, use Windows Explorer to launch the setup program from the CD
Click on MaxNeighborhood Setup & Discovery Wizard to begin your installation.
MaxNeighborhood Wizard
When the Install MaxAttach Family screen
appears, click the Install MaxNeighborhood
button. The wizard will guide you through the
installation process.
If you have an older version of
MaxNeighborhood on your server, you will be
notified and asked if you want to un-install the
older version, before your newer version is
installed.
Installing the MaxAttach NAS 4100 5