Maxtor MaxAttach NAS 4100 Anleitung Seite 13

Maxtor MaxAttach NAS 4100
Modifying Default Network Settings for non-DHCP Service
MaxAttach
If is attached to a network without a DHCP server, your MaxAttach will be displayed with an
IP Address in the 169.254.xxx.xxx range. You must now assign a unique "Static IP Address" to your unit.
See your network administrator for an available IP address before proceeding.
To set an IP address, highlight the default name of your MaxAttach with a single mouse click and then select
the Change Settings button. You will receive a warning message about making changes - click OK.
Delete the default IP Address and enter your unique address, subnet mask, and gateway (if applicable).
Should you wish to change the default computer name MaxAttach Server Name, please do so now with
any combination of alpha-numeric characters (without spaces).
Then change the DHCP Client setting by
clicking the down arrow and highlighting
Disabled.
Next, click Apply to make the changes
permanent.Your MaxAttach will now
automatically reboot.
End this procedure by selecting the Close
button.
After your MaxAttach has rebooted, press the
Refresh button in the main
MaxNeighborhood window. When the
search is complete, your new settings should
appear. If not, go back to the top of this page,
and begin again.
Now, double click on the MaxAttach in the
MaxNeighborhood window to launch the
configuration screens on your newly enabled
MaxAttach.
Installing the MaxAttach NAS 4100 8