Intended Use; Technical Description; Connection - Waeco mobitronic Bedienungsanleitung

Intended use

4 Intended use
The cylindrical construction of the inverter makes it convenient to use inside
your vehicle.
Conventional car drink holders serve as an excellent storage area for the
device when it is being used (see fig. 2, page 3).
The inverter can be used to generate a 230 Volt output from a 12 Volt power source. The
230 Volt output can be used to power a 230 Volt consumer unit with a power consumption
of up to 100 watts.
The inverter can be used anywhere where there is a 12 V DC cigarette lighter socket. Due
to the non-sine wave voltage, some devices may heat up more than usual. The maximum
constant output is 100 Watts. Never connect devices that have a higher power require-
ment.
Note when connecting devices with an electrical drive (such as power drills and
refrigerators), that they often require more power than is indicated on the type
plate.
5

Technical description

The device has a compact design for portable use.
5.1 Key to the illustration on page 3
Digits Description
A Status LED
B 230 V AC output
C Negative contact
D Positive contact
6

Connection

Reversing the polarity of the the inverter will cause the fuse to blow in the 12 V
plug. The 12Voltsocket and the power supply must be rated to at least 15 A.
Do not put in a fuse with a higher rating than 15 A.
Make sure the plug is firmly connected in the socket (see fig. 1.4, page 3).
If the connection is losse, the plug may heat up.
Do not operate any consumers connected to the the device while driving the
vehicle.
If you connect the device to the cigarette lighter, remember that the ignition
must be turned on to supply it with power.
Always plug in the inverter into a 12 V socket first before you connect a con-
sumer.
12
MCI-100