Cleaning The Motor Block; After Cleaning; Storage - Silvercrest SSM 550 A1 Bedienungsanleitung

If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
➩
e
Fill the liquidiser
a few drops of mild detergent. Close the lid
and place the liquidiser
Insert the plug into a mains power socket and
activate the Ice Crush/Clean switch a couple of
times, causing the cutters
the water with maximum revolutions.
Afterwards, rinse the liquidiser
clear water, so that all detergent residues are re-
moved.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
r
ters ) from the the glass part:
➩
Remove the mixer jug
u
.
➩
Turn the plastic element
e
ment anti-clockwise, such that it allows itself to
be released from the glass element
Attention!
Take care with the cutters
Risk of injury!
with 750 ml of water and add
e
on the motor block
r
to plough through
e
out with lots of
e
(with the cut-
e
from the motor block
of the mixer attach-
.
. They are very sharp.
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic part
back onto the glass part
w
ling ring
u
.

Cleaning the motor block

➩
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the plastic surfaces.
➩
At every cleaning check that the contact switch
in the receptor for the mixer jug
ked by soiling residues. If you cannot dislodge
any blockages with the corner of a piece of pa-
per, make contact with Customer Services. Un-
der no circumstances should you use a hard ob-
ject, this could damage the contact switch.
➩
Remove any possible residues on the underside
of the motor block
stiff bristled brush. Ensure that nothing can enter
through the ventilation opening of the appliance.

After cleaning

Allow all parts to dry well before re-assembling and
re-using the liquidiser.

Storage

➩
If you do not intend to use the liquidiser for an
extended period, clean it thoroughly (see chapter
"Cleaning").
➩
Wrap the power cable
i
rage
➩
Store the liquidiser at a cool and dry location.
- 8 -
of the mixer jug
. Ensure that the sea-
is correctly fitted.
u
only with a dry cloth or a
y
around the cable sto-
on the base of the motor block
e
e
is not blok-
u
.