Troubleshooting - Carson X10N Onroad Chassis Betriebsanleitung

Troubleshooting

Trouble
Engine won't start
Engine stalls
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
Possible reason
Engine flooded. Too much fuel in engine.
Dead glow plug heater
Overheating
Overheating
Disconnected fuel pressure line
Carburettor loose
Transmitter or chassis power switch is not "ON"
Batteries have run down
Batteries have run down
Front and rear wheel nuts are too lose
Wrong action
Batteries have run down
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears
Solution
Remove glow plug. Pull pull-start 6-8 times, Beware
Remove glow plug. Place glow plug in heater. If the
dead. See also glow heater. (Wear gloves)
Place new glow plug in heater. If it glows dim or not
while holding finger tip over muffler (Wear gloves).
Reattach pressure line from exhaust pipe to fuel tank
lid.
Wash with soap and water, then use air filter oil (No
Check carb-lock bolt and nut. Press carb onto engine
block, tighten nut to prevent air leak.
Switch power on receiver or transmitter
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna and/or transmitter antenna
screw tight
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch "OFF" and clean out gears
CARSON X10N Chassis CARSON X10N Chassis
G
-
23 23