Showtime - Carson X10N Onroad Chassis Betriebsanleitung

Showtime... almost!
THIS PART!
G the ground and free.
heater onto the glow plug and give the recoil a sharp pull (picture 4).
recoil short sharp pulls rather than long ones. If the pull-start cord
start with a good puff of smoke.
5
If the engine has trouble idling at the rich setting, turn the idle screw
clockwise 1/8th of a turn at a time. This will increase the idle allowing
under the exhaust, so be prepared. Let the car idle like this for 2 - 3
use small increments when making these kinds of adjustments.
Racer Tip:
Factory setting of carburettor:
turns;
arm, then 1 full turn clockwise;
20 CARSON X10N Chassis
After run-in is finished the high speed needle valve should be open at
least 3 and 1⁄4 turns. A richer setup is better if outside temperature is
high.
6
fetter
7
fetter
Racer Tip:
lean the engine out.
magerer
niedrigere
Drehzahl
höhere
Drehzahl
magerer