Troubleshooting - Carson X10E OnRoad BRUSHLESS Betriebsanleitung

f. Troubleshooting
Problem Cause
Model doesn´t move Transmitter or chassis power switch is not "ON"
Polarity or battery type is wrong
Batteries have run down
Loss of control Batteries have run down
Antenna is missing or not attached properly
R/C model using same band (frequency) is nearby
Doesn´t run straight Steering trim is not adjusted correctly
Wheel nuts are too lose
Doesn´t stop Throttle trim is not adjusted correctly
Doesn´t reverse Throttle trim is not adjusted correctly
Running too slowly Batteries have run down
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears
All manuals and user guides at all-guides.com
Correction
Switch on power transmitter and receiver
Check polarity and battery type
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna and screw tight transmitter
antenna
Run model in different area or change crystal
Make adjustment of the trim at the turning knob
Tighten wheel nuts
Make adjustment of the trim
Make adjustment of the trim
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch „OFF" and clean out gears
CARSON X10E Onroad
GB
19