Check 1; Final Preparations - Carson X10N Onroad Chassis Betriebsanleitung

Check 1... 2... 3...

ST-TRIM knob to the left of the steering wheel. Turning left should
make the car turn left. Right = right.
Now it's time to set the throttle neutral position. Remove the air
cleaner from the carburettor.
mm to allow the engine to idle (picture 2). If it is open more than this,
making the car difficult to drive.
Use the TH-TRIM tab (picture 3) to move the servo arm into the neutral
to "drag". Adjusting the collars with a 1.5 mm hexagonal wrench will

Final Preparations...

then insert the spout into the fuel. Allow the bottle to decompress
4
2
3
TH-Trimm
Racer Tip 1:
Racer Tip 2:
rechargeable glow heaters for longer life.
Racer Tip 3:
To start the motor, use a fireproof glove!
CARSON X10N Chassis
1-1,5 mm
G
19