Before First Use; Use And Operation - Klarstein 10029787 Bedienungsanleitung

• Just cut off the packing band, then pull the carton up.
• Be sure freezer stays in upright position during moving it. Do not tilt it for more than 45°from upright. Never upset it.
• Do not apply force on any external part such as pipe, condenser, door and its handle for moving, freezer
must be well packed and secured in long distance transportation to avoid damage from impacting and or
great rocking.
Installation
The freezer should be placed on a flat and solid-top surface. It should be kept away from sunlight,
heat source, humid or mess place. The freezer should be kept away from the wall for a proper space
for good air circulation. When the freezer is placed in a cupboard, the rear of the cupboard must be
removed out for good circulation.
Before the freezer is plugged in, be sure that everything is in normal condition and the freezer can be plugged
in. When operating for the first time When operating is in normal condition and the freezer without any load
until it auto stops at the desired temperature, usually it takes 2 or 3 hours. Then set the thermostat to the re-
quired setting and place foods in.
Freezer's temperature can be adjusted by turning the knob of the thermostat. The closer to „3" position the
knob is set, the lower the temperature becomes. A medium setting is the most suitable for general operation.
The position „4" is cooler than the position „1". Freezer's temperature will vary depending on the quantity of
foods stored and the frequency of the door opening, In order to maintain good cooling efficiency and save
energy, We recommend you not to store too much foods and not to open the door too frequently.
CAUTION: When the thermostat has been turned clockwise to „4"position, do not attempt to turn it more
over. Otherwise it will be damaged.
Defrosting
• For the most efficient operation and minimum energy consumption, defrost the freezer when the frost
on the evaporator is excessive 3 to 4 mm thick. To start defrosting, turn the temperature control to "OFF",
unplug the freezer, remove the food and drawers. After the frost or ice has melted, discard the melted water
and dry up the interior of freezer. Then the freezer can be restarted by turning its thermostat to the desired
setting.
• Never use any sharp of metallic instruments (e.g. knives) to remove frost/ice from the evaporator as this will
damage the evaporator

Before first Use

Use and Operation

6