Electrolux GT368 Benutzerinformation Seite 56

56 www.electrolux.com
Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Large quantities of food to
be frozen were put in at
the same time.
The room temperature is
too high.
Food placed in the appli‐
ance was too warm.
The lid is not closed prop‐
erly.
The FastFreeze function is
switched on.
The lid is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The FastFreeze function is
switched on.
The temperature regulator
is not set correctly.
The lid is not closed cor‐
rectly.
The products' temperature
is too high.
Many products are stored
at the same time.
The thickness of the frost
is greater than 4-5 mm.
The lid has been opened
often.
Solution
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are un‐
damaged and clean.
Refer to "FastFreeze func‐
tion".
Refer to "Opening and
closing the lid".
Position the water drain‐
age plug in the correct
way.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Refer to "FastFreeze func‐
tion".
Set a higher/lower temper‐
ature.
Refer to "Opening and
closing the lid".
Let the product tempera‐
ture decrease to room tem‐
perature before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if neces‐
sary.