m-e VS-B10 Betriebsanleitung Seite 21

then the cables for this also need to be fed to the
outdoor intercom.
4. Use the mounting plate in order to mark the drill holes.
We recommend using a spirit level for orientation.
5. Drill the marked holes with a 6mm drill (please ensure
that there are no cables or pipes behind the location
where you are drilling) and then insert a dowel into
each hole.
6. Insert any cables for the power supply through the
rubber grommet that is supplied for this purpose and fix
this with the 4 screws (12).
7. Connect any power supply cable to the outdoor intercom
(terminal 19), insuring correct polarity.
8. Place the outdoor intercom on the mounting plate
(beginning from above at an angle) and then re-insert
the mounting screw (11) into the housing.
Connecting the door opener
The outdoor intercom has two potential-free contacts
(14 and 15), which can be switched independently of one
another via the app in order to control a door opener. You
can find a connection plan on page 28.
Adjusting the nameplate
The clear plastic cover can be pulled off by gripping it from
the side between your thumb and index finger and pulling
it forwards.
ENGLISH | VS-B10
21