Installing The Intenza+ Water Filter - Philips HD8830 Handbuch

Memo Memo Memo
Aroma plus
Espresso Cappuccino Coffee
1 Hot water
X
X 2 Milk clean
Calc
clean
Memo
Co ee
1
X
X 2
Memo Memo Memo
Aroma plus
Espresso Cappuccino Coffee
Hot water
1
X
X 2 Milk clean
Calc
clean

Installing the Intenza+ water filter

1 Place a container under the coffee dispensing spout.
2 Make sure the ESPRESSO, CAPPUCCINO, COFFEE and HOT
WATER/MILK CLEAN buttons light up continuously.
3 Press the COFFEE button.
-
The machine starts to brew a cup of coffee to prepare the inner circuit
for use.This coffee is not drinkable.
4 Empty the cup after the brewing cycle is finished.
5 Place a container under the hot water dispensing spout.
6 Press the HOT WATER/MILK CLEAN button once. The machine starts
dispensing water.
-
The HOT WATER/MILK CLEAN button flashes slowly.
7 Let the machine brew hot water until the no water light lights up
continuously.
Note: If you want to stop the manual rinsing cycle, press the HOT
WATER/MILK CLEAN button; to restart press the HOT WATER/MILK
CLEAN button again.
8 Fill the water tank with fresh water up to the MAX indication
The machine is ready for use.
Note: The automatic rinsing cycle starts when the machine has been in
stand-by mode, or switched off , for more than 30 minutes. When you
have not used the machine for 2 or more weeks, you will need to perform
a manual rinse cycle.
We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter 'Guarantee and support', section 'Ordering
maintenance products'.
English
13