Jet JPT-10B-M Gebrauchsanleitung Seite 9

Mounting jointer-planer to stand
Place the Jointer-Planer (F) onto the assembled stand and
attach with 4 socket head cap screws (BB), lock washers (KK),
and flat washers (JJ).
Tighten screws with 5mm hex wrench.
Jointer-planer assembly
Fence
Attach jointer fence (A) to back of jointer outfeed table (F3)
with two socket head cap screws (Z) and lock washers (MM).
Tighten screws with 5mm hex wrench.
Lock knobs
Fig 4
Fig 5
The Jointer-Planer comes equipped with two lock knobs to
secure the position of the jointer infeed table.
Install jointer infeed table lock knobs (V, R).
Extension table
Attach the planer outfeed extension table (J) to the main
planer table (F4) with three socket head cap screws (AA) and
flat washers (HH). Tighten screws with 5mm hex wrench.
Extension table adjustment
Two setscrews located underneath the extension table (J) are
used to adjust the height position of the outer (protruding)
edge, which must be slightly higher than the main planer
table (F4) in order to minimize snipe.
Using a 4mm hex wrench (provided), turn setscrews slightly
clockwise to raise the table.
Thickness table lock handle
Attach thickness table lock handle (U) and flat washer (T).
Cutterhead guard
Fig 6
Fig 7