Jet JPT-10B-M Gebrauchsanleitung Seite 11

Loosen clamping handle (J) for fence adjustment. Retighten
clamping handle.
Correct operating position:
Position yourselves offset to the infeed table (Fig 10.
Work piece handling:
Feed the work piece straight across the infeed table, holding
your fingers close together, guiding the work piece with the
palm of your hands.
Never put your hands under the cutter block cover.
Always keep your hands well clear of the cutter block
Do not pull the work piece back over the unguarded cutter
block
Always plane the work piece over its entire length.
Support long work pieces (longer than jointer tables) with
helping roller stands or table extensions.
Fig 9
Fig 10
Planing the face of a work piece up to 75mm thick:
Place the work piece against the jointer fence. Adjust the
cutter block guard to the height of the work piece. When
guiding the work piece, the hands slide over the cutter block
guard (Fig 11)
Planing the edge of a work piece (jointing) or planning work
pieces more than 75mm thick:
Place the work piece against the jointer fence.
Adapt the cutter block guard to the width of the work piece
(Fig 12).
Chamfering a work piece:
Place the work piece against the jointer fence.
Adapt the cutter block guard to the width of the work piece
(Fig 13).
Fig 11
Fig 12