Assembly Instructions; Safety Devices - HERKULES Schredder 4000 Profi Bedienungsanleitung

Place the unit in the vertical position as shown.
1. Fit the wheel axle to the base machine using the
screws shown but do not tighten up. .
2. Slide the mudguard into position between the
chassis and axle brackets. Now fully tighten the
four fixing bolts.
3. Attach the wheels to the axle and secure using
washers and split pins.
4. Lift up the foot stand (as shown arrowed) and
tighten the fixing screws.
5. Fit the two handles to the chassis, tighten the
fixing screws and rotate the machine into a
horizontal position..
6. Attach the main hopper to the top of the machine
using the hinges and the short black hand screw
supplied.
7. Attach the discharge hopper, snap it shut and fix
using one long black hand screw.
8. Secure the side hopper with the collar bolt and
secure with the second long black hand screw.
Fill the petrol engine with correct grade oil as shown
in the engine manual and full before attempting to
start.
Important:
Do not attempt to use this machine without
having first studied both the Engine Operators
manual and the Shredder Instruction Information
and safety features.

Safety devices

1. You will find safety switches
the side hopper as well as on main intake hopper
and the discharge cover. Safety screws
operate the switches, so that the machine cannot
start until all hoppers and covers are all correctly
fitted.
Under no circumstances should any changes be made
to any of these safety devices.
In both hoppers there is a rubber flap to prevent
material being ejected. The should be inspected on a
regular basis and replaced when worn.
A feed tool is provided to enable leaves and bulky
material to be safely fed into the machine. This is
stored at the side of the main

Assembly Instructions

®+¯
located on
¬+-
5