Positioning And Attaching The Carrying Handle; Cleaning; Troubleshooting; Disposal - Powerfix Energy-Saving Light Bedienungsanleitung

4. Close the sight cover
Install the sight cover
screws .
6
Positioning and attaching
the carrying handle
1. Select the location
IMPORTANT: The energy saving work light
must be placed on a level surface with a max.
slope of 6°. Maintain an adequate distance to
illuminated surfaces (at least 1 m).
2. Adjusting the angle
Loosen the adjusting screw
clockwise.
Set the desired angle.
Tighten the adjusting screw
wise.
3. Attaching the carrying handle
Loosen the adjusting screws
right of the work light, turning it counter-
clockwise.
Attach the carrying handle
adjusting screw
2
Tighten the adjusting screw
turning clockwise.
Attach to a tripod or wall with the precast
screw slot on the handle.

Cleaning

DANGER: Disconnect the product from the
mains before cleaning. Only clean the product
with a slightly dampened cloth.
Allow the energy saving work
light to cool down before touching. Do not use
aggressive cleaning agents or chemicals.
Start-up / Cleaning / Troubleshooting / Disposal
and screw in locking
8
, turning it counter-
2
, turning clock-
2
on the left and
2
between the
12
and spacer .
11
at both sides,
2

Troubleshooting

Problem / Possible
fault cause(s)
Product isn't - Not connected
working to the mains
Only some - Did you press
of the light the correct
bulbs light switch?
up
- Defective light
bulb
Connected - Plug not fully
devices inserted
aren't
working
IMPORTANT: All repairs require technical
knowledge. These must be performed by an
electrician.

Disposal

The packaging is made of environmen-
tally friendly materials, which may be
disposed of through your local recycling
facilities.
Energy saving light bulbs contain toxic
mercury and must therefore be disposed
of through hazardous waste or returned
to the respective hazardous substances
collection sites.
In accordance with European Directive 2002 / 96 / EC
relating to old electrical and electronic appliances
and its translation into national law, used electrical
equipment must be collected separately and recy-
cled in an ecologically compatible way.
Remedy
- Insert the plug
into the mains
socket
- Switch on switch
and / or
14 15
- Press the cor-
rect switch (see
"Switching on
the light bulbs")
- Replace the light
bulb (see
"Inserting /
replacing the
light bulb")
- Insert the plug
all the way
GB 17