Siemens QAW740 Installationsanleitung Seite 19

First time power supply
When power is supplied to the room unit for the first
time, the display that appears allows you can set the
device address. The next commissioning steps can
only be made if the device address has been
successfully set. For details, refer to "Device address
d" in section 3.4.
2.3 Setting procedure for the service level
1. Press the presence button for about 6
seconds until "A" appears on the
display.
2. Select the individual settings from the
following list by pressing the presence
button.
3. Adjust the individual values with the
setting knob.
Installation Instructions
74 319 0328 0 a - B1633
5