Electrolux SB315N Benutzerinformation Seite 60

60 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
The compressor does not
start immediately after
pressing the FASTCOOL
or after changing the tem‐
perature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
The temperature in the
appliance is too low/too
high.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function
is switched on.
The FASTCOOL function
is switched on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
water from flowing into
the water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or FAST‐
COOL function is switch‐
ed on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func‐
tion".
Refer to "FASTCOOL func‐
tion".
The compressor starts after
some time.
The compressor starts after
some time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
FASTCOOL manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or FASTCOOL func‐
tion".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.