Installation; Start-Up; Setting The Detection Range - Powerfix IAN 78526 Bedienungsanleitung

– the motion detector is not installed where there are
strong temperature fluctuations, e.g. due to heating
devices or air conditioners.

Installation

SHOCK! Before installation, switch off the electrical
circuit at the circuit breaker box or remove the fuse
from the fuse box.
Note: The recommended installation height is be-
tween 1.8 and 2.5 m.
Note: Before installation, ensure an optimal direc-
tion of motion. The motion detector reacts more sensi-
tively to movement from the side than to motion from
the front (see Ill. A). Therefore, we recommend install-
ing the motion detector
tion of movement.
Note: To attach the base plate
drill two holes. We recommend a drill with a 6 mm
diameter.
Remove the screws
tion area by screwing them in the
rotation (see Ill. B).
Insert the cable through the cable opening
base plate
Screw the base plate
Connect the cable to the screw terminal
motion detector as depicted in Ill. C.
Attach the cover of the connection area back to the
base plate
direction of rotation

Start-up

Turn the electricity back on. The device is now ready
for use.
Setting the detection range (Ill. D)
Note: the sensor range is max. 12 m (depending on the
surrounding temperature).
DANGER TO LIFE BY ELECTRIC
1
from the cover of the connec-
2
.
4
to the desired position.
4
by screwing the screws
4
.
Mounting / Start-up
to the side of the direc-
it is necessary to
4
direction of
2
of the
5
of the
3
in the
GB/IE 9