DeWalt DW071 Bedienungsanleitung Seite 31

• Place the clamp jaws around the wall track and
turn the wall mount clamping lock (12) in the anti-
clockwise direction to close the clamp jaws shut
on the track.
• Ensure that the wall mount clamping lock (12) is
securely locked.
Before attaching the tool to a wall track
ensure that the track is properly secured
to the wall.
• Alternatively, the tool can be hung on the wall
using the mounting holes (24) in the wall mount
(fig. C2).
- Hold the tool at the desired position against the
wall and mark the location of the two mounting
holes on the wall (fig. C4).
- Drill a hole at each of the marked locations
(required: ø 6 mm, approx. 35 mm deep).
- Insert a corresponding plug into each of the holes.
- Turn a screw into each of the plugs
(required: 6 x 50 mm).
- Hang the tool on the screws.
• Adjust the leveling knob (5) to stabilize the tool
when necessary.
• Adjust the tool for a level application.
Tripod set-up (fig. C5)
The tool has been equipped with a tripod receptacle
for mounting to the DE0736 tripod (optional) or any
other tripod with the required ratings stated in the
technical data.
• Place the tripod (25) on a relatively smooth and
level surface.
• Mount the tool to the tripod by turning the threaded
pin (26) into the receptacle (27).
• Adjust the tool for a level or plumb application.
Adjusting the tool (fig. D1 & D2)
The head can be set up either for level (fig. D1) or for
plumb (fig. D2) applications.
Level adjustment (fig. D1)
• Place the tool into the required position as shown.
• Read the air levels (9 & 18) to check whether the
head is level.
• If adjustment is required, proceed as follows:
• Turn the level adjustment knobs (10 & 17) until
the head is level. If you want to move the
bubble to the right, turn the knob to the left,
and vice-versa.
Plumb adjustment (fig. D2)
• Place the tool into the required position as shown.
• Read the air level (28) to check whether the tool
is level.
• If adjustment is required, proceed as follows:
• Turn the level adjustment knob (29) until the
tool is level. If you want to move the bubble to
the right, turn the knob to the left, and vice-
versa.
Aligning the laser line (fig. E1 & E4)
Level alignment
• With the tool switched on and the laser head
rotating, align the laser line with the position mark.
• If adjustment is required, proceed as follows:
With tool in floor set-up (fig. E1):
• The tool can be placed on any sturdy object to
obtain the required height.
With tool in wall set-up (fig. E2):
• Loosen the locking knob (16) and adjust the rack
pinion wheel (13) to set the tool to the correct
position. Tighten the locking knob (16).
With tool in tripod set-up (fig. E3):
• Adjust the tripod to set the tool to the required
height.
Plumb alignment (fig. E4)
• With the tool switched on and the laser head
rotating, align the laser line with the position mark.
• If adjustment is required, proceed as follows:
• Move the tool as required. If the tool is attached
to the wall mount, loosen the locking knob (16)
and adjust the rack pinion wheel (13) to set the
tool to the correct position. Tighten the locking
knob (16) (fig. E4).
• Turn the level adjustment knob (30) until the head
aligns with the position mark.
Instructions for use
Always observe the safety instructions
and applicable regulations.
E N G L I S H
31