Searching For A Channel - AUDIOLINE Power PMR 40 Bedienungsanleitung

Searching for a channel

Signals are searched for in the eight channels in a continuous
cycle. The
is detected, the channel search stops. The Ready LED flashes
once per second.
Press the PTT button to enable radio communication.
If the PTT button is not pressed or the channel is inactive,
channel search resumes after five seconds.
Start / End channel search
Resuming search for a channel
/
Excluding a channel
If a channel found during the channel search process should not
be considered for subsequent use, it can be excluded. All the
channels are taken into consideration again when a new chan-
nel search is started.
/
☞
It is possible to exclude all channels with the exception of
the "home channel". The "home channel" is the channel you
currently configured, when start to scan, the radio searches from
home channel.
Operating the Walkie-Talkies
icon appears in the display. If an active channel
Start/End the search for a channel
Continue the search for a channel
Press and hold down. The channel is excluded
and the channel search automatically resumed.
GB
9