Standard Accessories - Hitachi Koki CF 18DSL Bedienungsanleitung

English
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CF18DSL / CF18DSAL
: Cordless Steel Rebar Cutter
Read all safety warnings and all instructions.
Always wear eye protection.
Wear head protection
No open fl ame; Fire, open ignition source and
smoking prohibited
Keep your hands away
Keep your face away
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V Rated voltage
D max The maximum diameter that can be cut
Disconnect the battery
Light switch: Cannot be used with this tool
Switching ON
Operates the same on either side
Remaining battery indicator switch
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
Bites into rebar
Prohibited action
Warning

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 204.
Standard accessories are subject to change without notice.
APPLICATIONS
Cutting rebar to be used for reinforcing concrete
SPECIFICATIONS
Model
Voltage
Up to 16 mm
Cutting capacity
Cutting speed
Max. Rebar
hardness
Head angle of
rotation
Dimensions 370 × 90 × 306 mm
(L×W×H) (without side handle)
Weight* 6.6 kg (BSL1850)
* According to EPTA-Procedure 01/2003
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in Fig. 3.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
● Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
6
CF18DSL CF18DSAL
18 V
Up to 20 mm
diameter diameter
4 sec. 6.5 sec.
Tensile strength 490 N/mm
345° 360°
413 × 103 × 316 mm
(without side handle)
9.4 kg (BSL1850)
2