Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL CE-CB 18/254 Li Originalbetriebsanleitung

synthetic polishing bonnet. Make sure that
the synthetic polishing bonnet is free of any
foreign bodies.
2. Remove the polish layer in the same order in
which you applied the polishing agent to the
paintwork. Be sure to follow the instructions
issued for using the waxing and polishing
agent.

7. Replacing the power cable

Danger! Information on the charger
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Wash the polishing bonnets only by hand and
let them air-dry.
•
When the polishing machine is not being
used it should be stored face up with the po-
lishing bonnet removed so that the polishing
disk can dry and retain its original shape.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_CE_CB_18_254 Li_SPK9.indb 20 Anl_CE_CB_18_254 Li_SPK9.indb 20
GB
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
11. Fault
The machine does not work
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.
- 20 -
28.07.2017 08:09:23 28.07.2017 08:09:23