Technical Data - FLORABEST FAHE 18 A1 Betriebsanleitung

Technical Data

Cordless pruner ......................FAHE 18 A1
Motor voltage .................. 18 V
Max. spindle rotation speed .....2500 min
Protection class ....................................III
Protection category ...........................IPX0
Chain speed v ..................... max. 5 m/s
0
Weight (incl. accessories) .. approx. 4.0 kg
Volume oiltank.............................70 cm
Chain bar ........8" Oregon 080NDEA318
Chain ......................... Oregon 91P033X
Chain pitch ...................3/8" (9,5 mm)
Number of chain drive links ............. 33
Chain width ............................ 1.3 mm
Teeth of the sprocket chain wheel ........ 6
Sawing length ..................approx. 20 cm
Acoustic pressure level
(L ) ............. 85.7 dB(A); K
pA
Sound power level (L
measured .....95.8 dB(A); K
guaranteed ........................... 99 dB(A)
Vibration at the handle
(a ) ............... < 2.5 m/s
h
Battery (Li-Ion) ........ LLR08-CA5-200-1.5Ah
Nominal voltage ......................... 18 V
Capacity ................................ 1500 mAh
Charging time ....................... approx. 1 h
Recharger ......................JLH282101500B1
Nominal consumption ..................... 40 W
Voltage input .. 100-240 V~, 50 Hz/60 Hz
Voltage output ............. 21 V
Protection class ................................
Protection category ...........................IPX0
1.5 Ah
=3.0 dB(A)
pA
)
WA
=3.0 dB(A)
wA
; K = 1.5 m/s
2
1500 mA
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration of
conformity.
Technical and optical changes can be
-1
carried out in the course of further devel-
opment without notice. All dimensions, ref-
erences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the basis
3
of the instruction manual, cannot thus be
considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
2
which the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based on
estimated exposure under actual
usage conditions (all parts of the
operating cycle are to be consid-
ered, including, for example, times
during which the power tool is
turned off and times when the tool
is turned on but is running idle).
II
GB IE CY
7